How do I identify a Ford cylinder head?

Identifying a Ford Cylinder Head
To identify a Ford cylinder head, you can follow these steps:
1. Check the top of the head under the valve cover: Look for any code number at either end of the head if you have the valve cover off.
2. Inspect the bottom of the head: In some cases, you may need to remove the head to read the code, as it appears on the underside of the head.
3. Examine the side of the head just under the valve cover lip: If the head has been removed, the code may appear on the top, bottom, or side of the head.
Once you locate the code mark, make sure to write it down for reference.
It’s worth noting that there are different types of Ford cylinder heads, such as the FE Series, MEL, and World heads . Each series may have its own specific identification methods and casting numbers. For example, World Products offers Windsor and Windsor Jr. heads for Ford engines, with the casting number located on the right side of the head, between the second set of rocker studs.
Remember, correctly identifying the cylinder head is crucial when replacing it, as it ensures you get the exact duplicate replacement part.
I hope this helps you identify a Ford cylinder head! Let me know if you have any further questions.

Where is the cylinder head casting number on a Ford?

The casting number is located where the starter bolts up to the bell housing. Numbers can be horizontal or vertical. In some cases, they are not there at all! Head casting number is under the cylinder head.

How do I identify my Ford 351 head?

Here’s a 4v. Head look at the size of these ports. Notice how these ports are larger see how large those ports.

Do cylinder heads have serial numbers?

You can identify the type of head by the raised casting part number found on the bottom, usually on the carb side. By comparing this with the serial number on the front, you may be able to determine if an incorrect head has been restamped.

How do you identify a cylinder head?

Cylinder heads may be identified by their casting number, located between the #4 and #5 pushrods. General identification is as follows: 850-1100 heads have a heater tap at 90 degrees to the centerline of the engine. The space between the thermostat housing and the valve cover is small, at 1/16″

How do you decode Ford engine casting numbers?

The first digit is a letter and represents the decade in which the part was designed. A = 1940s, B = 1950s, C = 1960s, D = 1970s, E = 1980s, F = 1990s. The second digit will be a numeral, and will represent the year within that decade (i.e. C2 = 1962; E7 = 1987).

What are the different cylinder head designs?

Design

Type	Camshaft location	Intake valves location
Sidevalve (flathead)	Block	Block
Inlet over exhaust (IOE)	Block	Head
Overhead valve (OHV)	Block	Head
Overhead camshaft (OHC)	Head	Head

Where are the casting numbers on Ford FE heads?

The casting number is on the right (passenger) side of the block, in the front. FE (330-428 SCJ) note: nearly all FE blocks have 352 cast on the front of them.

How do I identify a Ford part?

The first digit of the prefix. Is the decade the part was first used the second digit is for the year of that decade.

How do I identify my Ford engine?

The tag is a series of numbers and letters etched in and used to decipher the year, make, and model of you engine. It is found underneath the bolts on the left or right side of the engine, near the front of the car. You can find the tag here on all six-cylinder engines made after 1964, and on some V8 engines.

How does Ford number their cylinders?

So thank you so much for watching guys i do appreciate. It please comment down below if you have any questions. Thanks again.