AHG Auto Service » Make » Lexus » How do you reset the TPMS on a Lexus rc350?

How do you reset the TPMS on a Lexus rc350?

How to Reset the TPMS on a Lexus RC350
To reset the TPMS (Tire Pressure Monitoring System) on a Lexus RC350, you can follow these general steps:
1. Check tire pressure: Start by checking the tire pressure in all four tires. Ensure that they are inflated to the recommended PSI (pounds per square inch) as specified in your vehicle’s manual or on the driver’s side door jamb.
2. Turn on the ignition: Turn on the ignition without starting the engine. Make sure all the doors are closed.
3. Locate the TPMS reset button: Look for the TPMS reset button in your vehicle. The location of the button may vary depending on the model and year of your Lexus RC350. It is usually located near the steering wheel or on the dashboard.
4. Press and hold the TPMS reset button: Press and hold the TPMS reset button for a few seconds until the TPMS light on the instrument panel starts blinking.
5. Release the TPMS reset button: Release the TPMS reset button after the TPMS light blinks for a few seconds.
6. Drive the vehicle: Start the engine and drive the vehicle for a few miles at a speed of at least 30 mph (48 km/h) to allow the TPMS system to recalibrate and recognize the new tire pressures.
7. Check TPMS light: After driving for a while, check if the TPMS light on the instrument panel has turned off. If it has turned off, it means the TPMS system has been successfully reset.
Please note that the exact procedure may vary depending on the specific model and year of your Lexus RC350. It is always recommended to consult your vehicle’s manual or contact a Lexus dealership for the most accurate and up-to-date instructions.

How do you reset the TPMS on a Lexus RC?

Figure 1: Identifying the data link connector terminals.

  1. Set the tire pressure to the specified value.
  2. Turn the engine switch on (IG).
  3. Press and hold the tire pressure warning reset switch for 3 seconds or more until the tire pressure warning light blinks 3 times (see Figure 2).

How do you reset TPMS if there is no button?

Check your vehicle manual. If your TPMS is indirect, your mechanic / tire shop will need to manually reset the sensors after changing your tires or switching them around. If you have a DIRECT TPMS system, then there is no additional maintenance to reset the system.

Where is the TPMS reset button Lexus?

So first we’re going to scroll to the right. Keep coming till you go to that settings. And you want to keep coming down or up vehicle settings go to where it says TPMS.

How do you relearn the TPMS on a Lexus is350?

Using the TPMS Reset Button
Turn the vehicle’s ignition to “on” without starting the engine; hold the TPMS reset button until the light flashes three times and release the button. Start the car and give it about 20 minutes—the warning light should disappear.

Where is the TPMS reset button located?

Set the parking brake. Look for a button to the left of the steering column labeled with the TPMS icon if it’s there push and hold it until the TPMS indicator in the instrument panel blinks twice.

Can I reset my TPMS myself?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait about 20 minutes for the sensor to refresh. You will find the tire pressure monitor reset button under the steering wheel. Refer to your vehicle’s owner’s manual if you can’t find it.

How do you manually reset TPMS?

Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The tire pressure monitor reset button is typically located under the steering wheel. Refer to your vehicle’s owner’s manual if you’re unable to locate it.

How do you reset the TPMS on a 2015 Lexus?

Using the left and right arrows select the setting icon. Then use the up and down arrows to scroll to TPMS. Press and hold the center button to recalibrate the system. It’s as easy as that.

How do I clear my TPMS check?

On press the home button on the touch. Screen then touch vehicle settings touch tpms calibration then select calibrate if calibration failed to start appears repeat the previous. Step the calibration.

How do you reset the TPMS on a 2015 Lexus rc350?

1) Set the tire pressure to the specified value. 2) Turn the engine switch on (IG). 3) Press and hold the tire pressure warning reset switch for 3 seconds or more until the tire pressure warning light blinks 3 times (see Figure 2).

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment