AHG Auto Service » Make » Ford » How long does a Ford wet belt last?

How long does a Ford wet belt last?

The Ford wet belt, also known as the wet timing belt, is used in Ford EcoBoost engines. It is different from a traditional timing belt as it runs inside the engine rather than on the outside. According to Ford’s recommendation, the wet belt should be replaced every 10 years or 150,000 miles . However, there have been cases where the wet belt has failed before the recommended replacement interval due to factors such as lack of servicing, poor maintenance, or incorrect oils used. It is important to note that the failure rate of the wet belt can vary depending on various factors, including driving conditions and maintenance practices . If you have concerns about the condition of your wet belt, it is advisable to consult with a qualified mechanic or Ford dealership for an assessment and to determine the best course of action .

When should I replace my wet belt?

Vehicle manufacturers all have different recommended replacement intervals ranging from 100,000 km to over 150,000 km. Some workshops and dealerships are now recommending shorter replacement intervals as belt failures are occurring at much lower mileages.

Which Ford cars have wet belts?

And the best part for Ford is the 1.0 Ecoboost and 1.5 which are timing chain in the last models still have a wet belt on the oil pump. So the timing chain models still have the engines die due to bits of rubber… in the oil pump.

Which Ford engine has a wet belt?

And the best part for Ford is the 1.0 Ecoboost and 1.5 which are timing chain in the last models still have a wet belt on the oil pump. So the timing chain models still have the engines die due to bits of rubber… in the oil pump.

What is the difference between a wet belt and a timing chain?

It’s simple, they both perform the same function which is to synchronize the rotation of the crankshaft and the camshaft(s) so that the engine’s valves open and close at the proper time. They both operate in the same way and the only difference is their shape and the materials they are made of.

How much does it cost to replace a wet timing belt?

The average timing belt replacement cost in the UK ranges from £300 to £650. The total timing belt replacement cost will depend on the make and model of your car. As you can see, the cambelt change prices vary from one car make to another.

How do you know if your wet belt is bad?

There are no apparent signs to detect problems with the oil bath belt. However, if the wet belt is worn, the engine may have difficulty starting or run poorly at idle and operate erratically at high speeds. Although wet belts are less prone to breaking, their teeth can come loose.

Do wet cam belts last longer?

Modern well made cambelts, dry or wet, should last the life of a car doing an average annual mileage (e.g.Ford Zetec engine) as long as the belt has a reliable tensioner arrangement and only drives the cam shaft(s) which is(are) unlikely to seize.

Are Ford wet belts reliable?

The majority of issues reported with wet belts in EcoBoost engines have been with oil contamination and degrading of the belt over time, so the fact that you have followed the service schedule minimises the risk of a failure.

What to do if your belt gets wet?

Once it is damp, the next step is to apply a thick coat of high-quality leather conditioner. They contain oils that the leather will absorb which will replace the lost oils caused by the evaporating water. You will need to massage the conditioner into the belt and then leave it to dry for about 8 to 10 hours.

What Ford engines use a wet belt?

And the best part for Ford is the 1.0 Ecoboost and 1.5 which are timing chain in the last models still have a wet belt on the oil pump.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment