Where is the inertia switch on a 2018 Ford Transit?

Introduction
The inertia switch on a 2018 Ford Transit is a safety feature that shuts off the fuel pump in the event of a collision or other impact. While the location of the inertia switch may vary depending on the specific model and configuration of the vehicle, there are some common locations where it can be found.
Location of the Inertia Switch
Based on the search results, the location of the inertia switch on a 2018 Ford Transit can vary. Here are some possible locations:
1. Front Passenger Footwell: The inertia switch may be located in the front passenger footwell near the kick panel.
2. Passenger Side Kick Panel: Ford usually installs inertia switches on the passenger side kick panel.
3. Toe-board, Right of Transmission Hump: On a 2015 Ford Transit, the inertia switch is located in the toe-board, to the right of the transmission hump, in the passenger-side footwell.
It’s important to note that these locations are based on general information and may not apply to all 2018 Ford Transit models. To get the most accurate information about the specific location of the inertia switch in your vehicle, it is recommended to consult the owner’s manual or contact a Ford dealership.
Conclusion
The inertia switch on a 2018 Ford Transit is a safety feature that shuts off the fuel pump in the event of a collision. The exact location of the inertia switch may vary, but common locations include the front passenger footwell, passenger side kick panel, or toe-board in the passenger-side footwell. For the most accurate information, it is recommended to consult the owner’s manual or contact a Ford dealership.

What is the mode button on a Ford Transit?

Selectable Drive Modes allows you to tailor your Transit Custom’s performance by choosing from two available drive modes: Normal and for maximum efficiency, EcoMode. The system adjusts various settings to optimise performance for the conditions.

Is there a reset button for the fuel pump?

The fuel pump shut-off switch has a red reset button on top of it.

Where is the inertia switch on a 2016 Ford Transit?

In this van. It’s actually back here where the jack. Goes. And what you look for is this little you see the fuel symbol with the slash through it.

Where is the inertia switch on a 2018 Ford Ranger?

If you have power at the fuses, you will most likely have an inertia fuel shutoff switch in the driver/passenger side footwell area (possibly hidden behind the kick panel).

How do I reset my Ford Transit?

Performing a Master Reset:

1. Start your vehicle. Ensure your vehicle is in park and running, not in accessory mode.
2. Press Settings on your vehicle’s SYNC screen.
3. Choose General.
4. Scroll down and press Master Reset.
5. Press Continue.

Do Fords still have inertia switches?

Like it or hate it, Fords Inertia switch was still a great safety feature. But why then would Ford stop using them? The simple answer is, they haven’t. Granted modern Ford vehicles do not still use the switch with the red button, however they still utilize a fuel pump shutoff feature.

What does a tripped inertia switch do?

On this end there’s a rubber diaphragm. Which allows you to reset the switch just press the diaphragm. And it will reset the switch in the event of it being tripped. On the other.

Where is the inertia switch located?

It is typically located in the rear of the vehicle between the electric fuel pump and its power supply. It can be found on the passenger side in some vehicles, right behind the glove compartment. There should be a picture or wording that indicates the inertia switch is behind the plastic panel.

Where is the fuel pump reset switch located?

If it was in the up position. Then it means the switch is off and power isn’t going to the fuel pump this switch could be activated if you’re in an accident. If you have a blown tire.

How do you reset the fuel pump on a Ford Transit?

Dear customer, on your ford transit, the fuel pump off switch is located behind an access panel on the rear side trim panel, near the liftgate. The fuel pump shut-off switch has a red reset button on the top.